Service Manual

MOWER DECKS
8-15Floating Deck Mid-Size Service Manual
8
3. Install a bearing into the other side of the spindle
housing (Fig. 1198).
Fig 1198 PICT-1211
4. Insert the spindle shaft into the spindle housing
assembly (Fig. 1199).
Fig 1199 PICT-1212
5. Slide the bearing shield onto the spindle shaft (Fig.
1200).
Fig 1200 PICT-1214
6. Slide the pulley assembly onto the spindle shaft so
the welded center bore of the pulley is facing away
from the spindle housing (Fig. 1201).
Note: If the spindle has a dual pulley, the smaller
size pulley faced the spindle housing.
Fig 1201 PICT-1216