Service Manual

LINKAGE

4-127Floating Deck Mid-Size Service Manual

3. Adjust the left and right neutral stud until the clevis

pin in the yoke touches the back end of the slot in

the control arm (Fig. 0772).

1. With the machine on jack stands, place the speed

control lever in the neutral position.

2. Hold the OPC levers down.

Note: The OPC levers must be held down whenever

the speed control lever is out of the neutral

position or the engine will kill.

Fig 0772 ﬁ g. 51 G001969

Mechanical or hydraulic jacks may fail to

support machine and cause a serious injury.

• Use jack stands when supporting machine.

• Do not use hydraulic jacks.

A. Neutral control linkage E. Slot in control arm

B. Yoke bracket

C. Neutral stud F. Celvis pin

D. Nut G. Spring

H. Back end of slot