Service Manual

4-4 Power Max Service Manual

CONTROLS

5. Lift the metal latch pawl off the hex on the cable

lever. Lift out the latch trigger and spring. Note the

orientation of the pawl to the lever for reassembly

(Fig. 023).

Fig 023 MVC-837X

6. Rotate the cable until the barrel ﬁ tting slides off the

cable lever (Fig. 024).

Fig 024 MVC-554F

Fig 026 MVC-758F

2. Slide the latch trigger over the boss until it is fully

seated, making sure that the stop on the trigger

lever is above the stop on the quick lever, as shown.

While holding the trigger lever in place, rotate the

hooked end of the spring until it hooks under the

front edge of the trigger lever as shown (Fig. 026).

Fig 025 MVC-759F

1. Begin assembly by dropping the latch spring over

the boss. The straight end of the spring should be

down with the hooked end up (Fig. 025).

Reassembly

A. Latch trigger