Service Manual

9-10 Power Max Service Manual

WHEEL CLUTCH

TRACTION DRIVE SYSTEM

Fig 150 MVC-039X.jpg

4. Install long end of spring to cut out on the pivot plate

(Fig. 150) and the short end of the spring to the

frame (Fig. 151).

Fig 149 MVC-039X.jpg

3. Install the speed control linkage through the pivot

plate and install the hair clip into the hole of the

speed control linkage on the outside of the pivot

plate (Fig. 149).

Fig 151 MVC-041X.jpg

5. Install friction wheel assembly. You can lay the

shift mechanism onto the housing and insert shift

shaft into friction wheel assembly in the direction

shown. It is important that the friction wheel and shift

mechanism are to the right of the snowthrower (Fig.

152).

Note: Make sure the wheel is free of dirt, oil, anti-

seize or any other lubricant.

Fig 152 MVC-031XYX.jpg

A. Hairpin Cotter B. Speed Control Link

A. Spring