Service Manual

3-2 Power Max Service Manual

3. Pull the front shroud forward and up to remove. Slide

the rear cover to the rear and rotate it clockwise to

slip over the electric starter button and extension

cord plug located in the left rear corner (Fig. 004).

Fig 004 MVC-900XB

When depressed the primer button pressurizes the

carburetor bowl. Fuel is forced up the main tube to

the carburetor venturi. This line and button are the

atmospheric vent for the carburetor bowl. If the line

is kinked or the vent hole in the bulb is plugged, the

carburetor may ﬂ ood.

Fig 006 MVC-863XA

To remove the ignition switch, pull the wire harness off

the switch terminals. The switch is a snap in type. To

remove the switch, depress the ears on the switch body

(Fig. 006) and push the switch out through the rear of

the shroud. Switch troubleshooting is provided in the

electrical section.

Fig 005 MVC-865XA

To remove the primer button, pull the primer line off the

stem and compress the tabs. The primer will push out to

the rear (Fig. 005).

ENGINE

Primer Button

Ignition Switch