Service Manual

8-2 Power Max Service Manual

3. Remove the screw securing each end of the

sprocket shaft (Fig. 101).

Fig 101 MVC-9022X.jpg

4. Pull the right hand end of the shaft out of the traction

housing. Optional: The chain contains a master link,

which also can be removed (Fig. 102).

5. Slide the shaft out of the sprocket, slip the chain off,

then remove the sprocket.

Note: There is a thrust washer that may stick to the

bushing on the sprocket (Fig. 102).

Fig 102 MVC-771X.jpg

NON-WHEEL CLUTCH

TRACTION DRIVE SYSTEM

Fig 100 MVC-9012X.jpg

2. Remove the upper and lower covers and bottom pan

(Fig. 100).

A. Upper Cover C. Bottom Pan

B. Lower Cover

A. Thrust Washer