Operator's Manual

4.InstallingtheAuger/Impeller
DriveControlLinkage
1
Clevispin
1
Cotterpin
Procedure
1.Loosenthejamnutabovetheclevisontheupper
controlrod(Figure8).
Figure8
1.Uppercontrolrod
4.Cotterpin
2.Jamnut5.Lowercontrolrod
3.Clevis6.Clevispin
2.Aligntheholesintheclevisandthelowercontrol
rodandinserttheclevispin(Figure8).
3.Checkthedistancebetweenthetopofthehandgrip
andthebottomoftheauger/impellerdrivecontrol
lever(Figure9).
Figure9
1.Handgrip
3.1to2inches(2.5to5cm)
2.Auger/impellercontrol
lever
4.5inches(12.7cm)
Note:Thedistanceshouldbeapproximately5
inches(12.7cm).
4.Presstheauger/impellerdrivecontrolleverslowly
towardthehandgrip.
Note:Theamountofforceneededtocompressthe
leverincreasesnoticeablywhenyouremovetheslack
fromtheauger/impellerdrivebelt(approximately
1/2ofthelevermovement).Theadjustmentis
correctwhentheforcebeginstoincreaseandthe
distancebetweenthetopofthehandgripandthe
bottomoftheauger/impellerdrivecontrolleveris1
to2inches(2.5to5cm)asshowninFigure9.
Note:Iftheforcedoesnotnoticeablyincrease,
removethebeltcover(refertostep2ofReplacing
theTractionDriveBelt)andmeasure2inches(5cm)
abovethehandgripatthepointwhereyouremove
theslackfromtheauger/impellerdrivebelt.
5.Toadjustthedistance:
A.Removetheclevispin.
B.Loosenthejamnut.
C.Threadtheclevisupordowntoincreaseor
decreasethedistancebetweenthetopofthe
handgripandthebottomoftheauger/impeller
drivecontrollever(Figure8).
6.Whentheadjustmentiscorrect,installtheclevispin
andsecureitinplacewiththecotterpin(Figure8).
7.Tightenthejamnuttosecuretheclevis(Figure8).
9