Service Manual

Differential Kit Installation (cont'd)
Figure 124
6. Slide the thick washer onto the latch rod then
install the
left pivot arm, again being sure to install
the special washer between the pivot arm and the
frame. Secure the
left hand pivot arm with the
flanged head capscrew
and the nylon locknut.
7.
8.
9.
Install the right hand half of the chain guard with
the three Phillips screws.
Slide the thrust washers then the wheels onto
each end of the
axle. Secure with klik pins.
If this is the first time the differential kt is being
installed and the product was produced in
'88,
install the new belt cover as shown in Figure 125.
This belt cover provides clearance for the
differential when the wheels are in the forward
position.
Figure 125
10. Check for proper operation of all controls and
adjust
if necessary.
90
Power Shift Snowthrowers