Service Manual

Auger Gear Box Installation (cont’d)
Figure
97
14.
15.
16.
17.
Stand the snowthrower on the front housing and
install the lower belt cover using the
two flanged
head self tapping capscrews.
Secure the auger halves to the auger shaft by
installing the long shank hex head screws through
the auger
shaft.
NOTE: The head of the capscrews should rest
against the spacers.
Check to insure the skids and scraper are properly
adjusted. For more information on this see Skids
Installation, page
78, and Scraper
Installation, page
79.
Complete impeller servicing by performing a final
operational check.
Power Shift Snowthrowers