Operator's Manual

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
Wheels
2
Long spacer 1
Short spacer
1
1.
Pushnuts
2
Install the wheels.
2.
No parts required
–
Install the handle.
Discharge chute
1
Chute handle
1
Phillips head screws
3
Washers
3
3.
Locknuts
3
Install the discharge chute.
1. Installing the Wheels
1. T ur n the sno wthro w er onto its left side and place a
bloc k under the left axle end ( Figure 3 ).
Figure 3
1. Short spacer
2. Slide the shor t spacer and a wheel onto the right axle
end ( Figure 3 ).
Note: T he side of the wheel with 6 spok es m ust face
do wnw ard.
3. Put a pushn ut onto the end of the axle and use a
hammer to seat it fir mly in place ( Figure 4 ).
Figure 4
4. T ur n the sno wthro w er onto its right side and place a
bloc k under the right axle end.
5. R e peat ste ps 2 through 4 (see note belo w).
Note: Slide the long spacer and a wheel onto the left
axle end.
2. Installing the Handle
1. Cut the plastic tie that secures the control cable to the
handle .
Note: Hold the cable taut to ensure that it sta ys
connected at the bottom.
2. P osition the upper handle as sho wn in Figure 5 .
5