Service Manual
Right Handle
Removal
(cont'd)
5.
Remove the
small
hex head capscrew and locknut
that secures the torque rod to the traction lever.
Pull the torque rod out about
5
cm
(2”),
just far
enough to clear
the
impeller lever.
6.
Spread the impeller lever slightly and remove the
7.
Remove the self-tapping screw from the impeller
release cam.
lever and remove the locking tang.
8.
Remove the flanged head capscrew and the
self-tapping screw that secure the right handle
to
the control panel.
9.
Remove the four nylon locknuts securing the rear
cover plate to the lower handles. See Figure
111.
NOTE:
It
is not necessary to remove the lower
control rod
from
the shifting bellcrank.
Figure
111
10.
Remove the
two
flanged head capscrews from the
lower handle
and
remove the right handle.
11.
If
necessary, remove the impeller lever bushing
and the impeller lever from the right handle.
12.
Remove the impeller lever return spring from the
right handle.
13.
Remove the
E
clip securing the locking latch to
right handle and remove the locking latch and
locking latch spring from the stud.
14.
Complete disassembly by removing the handle
grip from the right handle.
Right
Handle Installation
NOTE:
If installing a new handle, be sure that the
warning decal is in place. The warning decal states the
importance of adjusting the cables to make sure that the
auger and transmission disengage completely.
1.
Place the right handle onto the studs coming from
the frame and secure with the
two
flanged head
capscrews.
locknuts.
NOTE:
The coverplate goes on top of the lower
handle brackets! See Figure
111
above.
3.
Slip the impeller lever bushing onto the cross rod,
then place the impeller lever into position. Slide
the cross rod through the
left
impeller lever hole
and snap the impeller lever bushing in place.
See
Figure
112.
2.
Secure the coverplate with the four nylon
4.
5.
6.
7.
82
Figure
112
Install the latching lever return spring and the
release cam onto the cross rod.
Insert the end of the traction cable into the release
cam and loosely secure the cable
in
the cable
bracket.
Insert the end of the impeller cable into the locking
tang and install in the impeller lever as shown in
Figure
113.
Secure with the small self-tapping
screw.
Secure the cross rod to the traction lever with the
small capscrew and nylon locknut.
Power Shift Snowthrowers