Operator's Manual

12
m-4503
2
1
Figure 7
1. Upper handle 2. Control bar
m-4504
1
2
Figure 8
1. Upper handle 2. Control bar
3. Install the upper handle as illustrated in Figure 9.
IMPORTANT: Y ou must route the control cable through
the cable guide before you tighten the handle lock
(Fig. 10).
m-4497
1
2
3
4
5
6
Figure 9
1. Lower handle
2. Upper handle
3. Handle lock
4. Cable guide
5. Curved washer
6. Knob
Installing the Control Cable
Models 38428 and 38429 only
m-2708
2
4
3
1
5
6
7
Figure 10
1. Cable guide
2. Control cable
3. Spring cover
4. Control bar bracket
5. T op hole
6. Bottom hole
7. 1/16 to 1/8 in. (0.16 to
0.32 cm) gap
1. Hook the spring to the round hole at the end of the
cable adjuster (Fig. 1 1).
2.
Secure the end of the cable to the cable adjuster as
illustrated in Figure 1 1.
897
4321
Figure 1 1
1. Spring
2. Cable
adjuster
3. Z fitting
4. Cable
3. Slide the spring cover over the spring and the cable
adjuster and push the spring end through the hole at
the end of the spring cover (Fig. 10).
4. Hook the spring into the top hole of the control bar
bracket (Fig. 10).
5. Move the control bar back toward the handle to
remove the slack in the cable.
6. Ensure that a 1/16 to 1/8 inch (0.16 to 0.32 cm) gap
exists between the control bar and the handle (Refer to
the inset in
Fig. 10). T o adjust this gap, refer to Adjusting the
Contr ol Bar on page 16.
IMPORTANT : The control cable must contain slack
when it is in the disengaged position.