Operator's Manual
16
• T
o clear snow from crushed rock or gravel, push down
on the handle to raise the rotor blades clear of the
loose material and push the snowthrower forward.
•
In snowy and cold conditions, some controls and
moving parts may freeze solid.
Do not use excessive
for
ce when trying to operate fr
ozen contr
ols.
If you
have dif
ficulty operating any control or part, start the
engine and let it run for a few minutes.
•
After clearing the snow
, let the engine run for a few
minutes to prevent moving parts from freezing. While
the engine runs, pull the recoil starter two or three
times to prevent it from freezing. Shut of
f the engine
and remove all ice and snow from the snowthrower
.
On models 38441 and 38442:
Operate the chute crank
several times to remove any ice and snow
.
Maintenance
Recommended
Maintenance Schedule
Service
Item
Service Operation
Initial
At
Storage
Comments
Control cable
Check the control cable. Adjust if necessary
. X X
Check and adjust
as needed.
Fuel tank
Drain the fuel and run the engine until the fuel tank
and the carbutetor are dry
.
X
Scraper
Check the scraper
. Replace if necessary
. X
Drive belt
Inspect the drive belt. Replace if necessary
. X
Spark plug
Clean, inspect, and gap. Replace if necessary
. X
Rotor blades
Inspect the rotor blades. Replace if necessary
. X
Tighten
fasteners
Check for loose fasteners and tighten them if
necessary.
X X
T
ighten fasteners
as needed.
CAUTION
POTENTIAL
HAZARD
•
If you leave the wir
e on the spark plug, someone could start the engine.
WHA
T CAN HAPPEN
•
Accidental starting of engine could seriously injur
e you or other bystanders.
HOW T
O A
V
OID THE HAZARD
•
Pull the wir
e off of the spark plug befor
e you do any maintenance. Also, push it aside so it
does not accidentally contact the spark plug.
Adjusting
the Control Cable
Periodically
check the control cable for proper
adjustment.
1.
Stop the engine.
2.
Move the control bar back toward the handle to
remove the slack in the cable (Fig. 10 or Fig. 12).
3.
Ensure that a 1/16 to 1/8 in. (0.16 to 0.32 cm) gap
exists between the control bar and the handle (Refer to
the inset in Fig. 10). T
o adjust the cable, go to step 4.
Note: The control cable must have slack in the
disengaged position.
4.
Adjust the cable as follows:
Models 38428 and 38429 only:
A.
Unhook the spring end from the top hole in the
control bar bracket (Fig. 10).