Service Manual

REWIND STARTER

2. Tie a sin

le knot in the end of the rope; then sin

the end with a li

hter to prevent the knotted end of

the rope from frayin

(see Fi

ure 62). Tie a simple

knot in the rope to prevent too much from retractin

until the starter handle is installed.

Figure 62

lbv0043d.bmp

3. Reassemble the starter and shroud with the four

screws and nuts. Remember the orientation of the

rope outlet.

4. The shroud must be assembled by slippin

the

shroud over the two studs on the cylinder head

then rotatin

the shroud down until the holes on the

ine block and shroud ali

n. Install the nuts on

the studs and two screws on the side opposite the

head. Note: Do not overti

hten. (See Fi

ure 63.)

Figure 63

0720-002