Service Manual

Single Stage Snowthrower Service Manual 5 - 23
DRIVE SYSTEMS
2. Using a needle nose pliers, remove the locking
clip on the master connecting link of the chain
(Figure 109). The master link can now be pulled
apart.
3. After removing the chain from the impeller and
crankshaft sprockets, remove the two self-tapping
screws retaining the stripper assembly (Figure
114 and Figure 115).
Figure 114 0217-065
Figure 115 0217-066
4. Next, remove all four bolts, two on the left side of
the impeller housing and two in the right side of
the impeller housing (Figure 116). Remove the
entire rotor assembly and stripper from the
snowthrower housing (Figure 115 and Figure
117).
Figure 116 0217-067
5. Next, remove the rotor shafts from the rotor
bushings at the impeller sprocket end cap and the
right hand end cap (Figure 118).
Figure 117 0217-068