Operator's Manual

10
DESCRIPTION USEQTY.
Knobs
Curved washers
Cable guide
Handle locks
Control bar
Upper handle
2
2
1
2
1
1
Installing the handle
Spring
Spring cover
Cable adjuster
Control cable
1
1
1
1
Installing the control cable
Installing the Wheels
1. Turn the snowthrower onto its left side and place a
wood block under the left axle end (Fig. 3).
2. Slide the short spacer and a wheel onto the right axle
end (Fig. 3).
The side of the wheel with six spokes must face
downward.
3.
Slide a pushnut onto the end of the axle (Fig. 3).

1
2
Figure 2
1. Short spacer 2. Pushnut
4. Using a hammer , strike the pushnut to seat it firmly in
place.
5. T
urn the snowthrower over onto its right side and
place a wood block under the right axle end.
6. Slide the long spacer and a wheel onto the left axle
end.
The side of the wheel with six spokes must face
downward.
m–4499
2
1
Figure 3
1. Long spacer 2. Pushnut
7. Repeat steps 3 and 4.
Installing the Discharge Chute
Models 38428 and 38429 only
1. Place the chute handle over the chute ring (Fig. 4).
2. Insert the dischar ge chute between the chute ring and
the chute handle. (Fig. 4).