Service Manual

PIVOTING ZONE START BRAKE

Assembly

1. If the brake mountin

plate was not removed from

the en

ine, simply reconnect the

roundin

lead to

the push-on terminal directly above the

round

strap stop (4) and continue with the reassembly

process.

Note: If the brake mountin

plate was removed,

hten screw (9) to 60 - 70 in. lbs. (6.78 - 7.91

Nm).

2. Secure the replacement brake plate to the en

ine

with shoulder screw (7). Ti

hten it to 90 in. lbs.

(9.2 Nm). Ensure that the brake plate pivots freely.

3. Slide the cable into the narrow slot on the brake

mountin

plate, and then push the cable into the

hole makin

sure the tabs lock into the bracket.

4. One end of the compression sprin

has a hook

shape to it; that end hooks over an indentation in

the brake plate. Squeeze the compression sprin

(A) and slip it over the cable between the brake

mountin

plate and brake plate. (See Fi

ure 90).

ure 90

0893-051a

5. Insert the leaded ball end of the cable into the

vertical slot (B) of the brake plate. (See Fi

ure 90.)

6. Operate the blade control bail to verify that the

brake mechanism stops within three (3) seconds.

There is no adjustment needed after this assembly

process is completed. (See Fi

ure 91).

ure 91

0891-1