Service Manual

Single Stage Snowthrower Service Manual 4 - 3
ENGINE REMOVAL AND INSTALLATION
1965 - 1985 MODELS, ENGINE
INSTALLATION
After performing the necessary servicing procedures to
your engine, install the engine back into the unit.
Proceed with the following:
1. Slide the engine into the engine mounting bracket.
Loosely install the four mounting nuts to retain the
engine to the mounting bracket (Figure 40).
Figure 40 0217-023
2. Install the engine mounting bracket that supports
the engine on the starter housing side. Loosely
install the starter housing nut (Figure 41). Tighten
the engine mounting bracket to the frame.
Note: On all 20” snowthrowers, install the small
self-tapping screw retaining the vane control rod
to the vane bracket. Refer to your parts manual if
additional guidance is necessary.
Figure 41 0217-024
3. Slide the fuel line or hose onto the carburetor
fitting. Compress the fuel line clamp and slide into
position.
4. On 20” models, install the lower shroud.
5. Install the switch terminal back onto the switch if
your unit is so equipped. (On some 1980 S-200
models, the key switch has pig tail leads running
to a receptable. This receptable should be
connected to the terminal.)
6. Install the choke linkage and choke control. Take
care not to bend or misform the choke control
linkage.
7. Slide the primer hose onto the primer fitting.