Service Manual

Single Stage Snowthrower Service Manual 3 - 9

CONTROLS/LOCATION AND OPERATION

3. To remove the upper shroud, remove the two

bolts and locknuts in the front corners of the

shroud (Figure 31).

Figure 31

4. Remove 3 screws that hold the face plate to the

control panel and let the face plate hang from the

starter rope.

5. Remove the gas cap and lift the upper shroud,

replace the gas cap. The chute ring and gears are

now all exposed.

6. The gears are held in the bracket by a shaft with a

push nut on either end (Figure 32). To remove the

shaft, remove one of the push nuts and pull the

shaft out.

Figure 32 1854-19

7. To reassemble, reverse the process.

Note: When installing the chute, the rounded

heads of the carriage bolts must be on the inside

of the chute. The smooth head prevents snow

from building up on the bolt head.

(A) Nameplate

(B) Control Panel

(D) Push Nut

(E) Chute Seal Retainer

(F) Chute Seal

(G) Upper Shroud

(H) Gas Cap

(A) Shaft and Push Nut