Service Manual

ELECTRIC START SYSTEM
6 - 6 Single Stage Snowthrower Service Manual
12. Remove the second starter bolt and remove the
starter assembly, wire harness, and starter switch
box (Figure 148).
Figure 148 1854-10
Installation
Reverse the removal procedures. Note: Incorrect
routing of the wire harness can cause electrical shock.
Route and fasten the wire harness away from all
moving parts.
SNOWMASTER 20”, 5200 – 5620/
TECUMSEH AH520 STARTER REMOVAL
1. Drain the fuel from the fuel tank using a pump type
siphon. Caution: Ignition of fuel can result in
severe personal injury of death. Store fuel in an
authorized fuel storage container.
2. Remove the three screws from the front of the
upper shroud, located between the directional
vanes (Figure 149).
Figure 149 2261-06-2
3. Remove the gas cap and cover the fuel tank
opening with a clean plastic bag and rubber band
to prevent debris from entering.
4. Remove the two self-tapping screws from either
side of the upper shroud to the handle and remove
upper shroud (Figure 150).
Figure 150 2261-06-3
5. Disconnect the spark plug wire from the spark
plug to prevent accidental starting.
(A) Starter Mounting Bolt (B) Motor
A
B
(A) Screws
(A) Screws
A
A