Service Manual

CONTROLS/LOCATION AND OPERATION

3 - 10 Single Stage Snowthrower Service Manual

Chute Seal

This system has a seal incorporated into the upper

shroud (Figure 33). This is to prevent melted snow

from seeping into the engine compartment. To replace

the seal, remove the upper shroud in the same manner

as accessing the chute gears. Turn the shroud over

and remove the 8 pushnuts. (Cutting them with a side

cutter is the best way to remove them.) Slide the seal

and retainer off the mounting pegs and replace the seal

and retainer. Install new pushnuts, using a socket to

push them into place.

Figure 33 1854-38

(A) Seal