Operator's Manual

2. Installing the Discharge
Chute
1. P osition the holes in the sides of the disc harg e c hute
o v er the bolts ends on the sides of the c hute handle .
( Figure 4 ).
Figure 4
1. Discharge chute 3. Knob
2. Bolt ends
2. Secure the sides of the disc harg e c hute with 2 w ashers
and 2 loc kn uts .
3. R otate the disc harg e c hute to the upright position.
4. Install the knob tightl y onto the bolt end at the rear of
the disc harg e c hute .
Product Overview
Figure 5
1. Discharge chute 4. Control panel
2. Chute handle 5. Rotor blade
3. Handle 6. Fuel tank
Figure 6
1. Choke lever
3. Primer
2. Key switch 4. Recoil start
5