Service Manual

Single Stage Snowthrower Service Manual 7 - 9
MAINTENANCE
5. Unfasten all the vanes at the vane mount. Refer
to "VANE REPLACEMENT" on page 7 - 6. The
vane mount and vane linkage can be removed
together. Using a punch, lightly drive the vane
link from the vane mount. Should the vane mount
or link be misformed or bent, replace.
Note: It will be necessary to support the vane
mount with a block of wood or vise when driving
the linkage from the vane mount (Figure 182).
Figure 182 0217-089
6. Reinstall the vane control assembly with the new
hardware. Use your parts manual as a guide
during reassembly. Lastly, using the appropriate
mounting screws, install the upper shroud.