Operator's Manual

10
3
m-2665
2
1
4
Figure 5
1. Engine
2. Chute control rod
3. Traction rod
4. Side plate
4. Position the left side of the handle assembly against the
left side of the snowthrower, align the handle mount
holes with the holes in the side plate, and secure the left
side of the handle assembly with two bolts and curved
washers until they are finger tight (Fig. 3).
Note: The concave side of the curved washer goes
against the outside of the handle.
5. Position the right side of the handle assembly against
the right side of the snowthrower, align the handle
mount holes with the holes in the side plate, and secure
the right side of the handle assembly with two bolts and
curved washers until they are finger tight.
6. Ensure that both sides of the handle assembly are in line
with each other and then torque the bolts that hold the
handle assembly to 200 in-lb (2250 Ncm). If you do
not have a torque wrench, tighten the bolts firmly.
7. Slide the wheels inward and insert each axle pin
through the hole in each wheel hub and through the
inner hole of the axle (Fig. 6).
1
3
2
473
Figure 6
1. Inner axle hole and wheel
hub
2. Outer axle hole
3. Axle pin
Note: To use tire chains (optional), install the axle pins
through the outer axle holes.
Installing the Speed Selector
Rod
1. Pull the speed selector arm (Fig. 7) to the most outward
position.
3
2
1
m-2672
4
Figure 7
1. Speed selector arm
2. Cotter pin
3. Flat washer
4. Speed selector rod
2. Move the speed selector (Fig. 8) on the control panel to
the R
2
(Reverse) position.
2
4
1
m-4035
3
Figure 8
1. Speed selector
2. Auger/impeller drive
control lever
3. Discharge chute control
4. Traction control lever
3. Rotate the speed selector rod in the trunnion (Fig. 9)
until the bottom end of the rod can slip into the hole in
the speed selector arm (Fig. 7).
m-2670
2
1
Figure 9
1. Trunnion 2. Speed selector rod
4. Install the speed selector rod into the selector arm, add
one flat washer on the rod, and secure it with a cotter
pin (Fig. 7).