Service Manual

T2® / T2-HP
TM
/ T3 HD
TM
23
Refer to Figure 15
Disassembly
1. Remove all external items previously dis-
cussed in their recommended order.
2. Remove the screws (8), separate side hous-
ing (2) from main housing (1).
Inspection
1. Inspect the bearing and bushing areas in the
side cover for wear or damage. Replace if
necessary.
SIDE HOUSING
Figure 15, Side Housing Removal
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. Apply a bead of sealant around the perim-
eter of the main housing face. See “Sealant
Application Diagram” on page 34.
3. Align the side housing (2) with the main
housing (1). Use care not to smear the seal-
ant bead.
4. Install the housing screws (8). Refer to the
screw tightening pattern on page 35.
5. When tightening the fasteners, refer to the
table on page 15 for the required torque
values.
8
Side Housing (2)
Main Housing (1)