Service Manual

Groundsmaster 360Hydraulic System Page 4 − 104
CrossTrax
TM
AWD Control Manifold (4WD Machines)
1. Cap screw (2)
2. Flange nut (2)
3. 90
o
hydraulic fitting
4. Mount (2)
5. Washer (4)
6. O−ring
7. O−ring
8. Washer (2)
9. 45
o
hydraulic fitting (2)
10. Mount plate
11. Straight fitting
12. Carriage screw (2)
13. AWD control manifold
14. Steering control manifold
Figure 126
2
12
14
FRONT
RIGHT
7
6
6
6
7
1
3
9
10
11
4
8
5
5
13
Removal (Fig. 126)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
WARNING
Before disconnecting or performing any work on
the hydraulic system, all pressure in the system
must be relieved. See Relieving Hydraulic System
Pressure in the General Information section.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
3. Raise and support operator seat. Locate AWD con-
trol manifold.
4. Thoroughly clean hydraulic hose ends prior to dis-
connecting hoses from the AWD control manifold. Label
all hydraulic connections for assembly purposes
(Fig. 127).