Service Manual

ManualsBrandsToro ManualsRiding ProductsGroundsmaster 360 2-Wheel Drive Multi-Purpose Machine

361

362

363

364

365

366

367

368

369

370

Groundsmaster 360 Operator CabPage 8.1 − 25

(Rev. A)

Disassembly (Fig. 16)

1. Park machine on a level surface, lower cutting deck

or implement and stop engine. Remove key from the

ignition switch.

2. To remove wiper blade, remove two (2) cap screws

and lock washers that secure wiper blade to wiper arm

assembly.

3. If necessary, remove wiper arm assembly:

A. Disconnect washer hose from wiper assembly.

B. Lift caps at top of wiper arms and remove flange

nuts that secure wiper arms to wiper motor.

C. Use suitable puller to remove tapered wiper arm

sockets from wiper motor shafts.

4. If access to wiper motor is necessary, remove roof

panel from top of cab to allow access to wiper motor as-

sembly (see Roof Assembly in this section). Remove

wiper motor components using Figure 16 as a guide.

Assembly (Fig. 16)

1. If required, install removed wiper motor components

using Figure 16 as a guide.

A. If wiper bracket (item 8) was removed, apply

bead of RTV sealant around wiper opening on inside

of headliner before installing bracket.

B. If jam nut (item 16) was removed, torque jam nut

to 100 in−lb (11.3 N−m) during assembly.

C. Make sure that wiper motor electrical connector

is secured to cab wire harness.

D. Secure roof panel to top of cab (see Roof Assem-

bly in this section).

2. If wiper blade was removed, apply medium strength

thread locker to threads of cap screws (item 2). Secure

blade to wiper arm assembly with two (2) cap screws

and lock washers.

3. If wiper arm assembly was removed:

A. Clean tapered wiper arm sockets and wiper mo-

tor shafts.

B. Run the wiper motor for one (1) cycle to allow the

motor to return to the normal OFF position.

C. Slide wiper arm sockets onto wiper motor shafts

so that the bottom of the wiper blade is 3 inches (76

mm) from the right side window trim (Fig. 17).

D. Secure wiper arm sockets to motor shafts with

flange nuts. Torque nuts from 16 to 18 ft−lb (23 to 25

N−m).

E. Install wiper arm caps over flange nuts.

F. Connect washer hose to wiper assembly.

Figure 17

(76 mm)

3 inches

Operator

Cab