Operator's Manual

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1
No parts required
–
Check the uids and tire pressure.
Operator’s Manual
1
Engine Operator’s Manual
1
Parts Catalog
1
Safety Video
1
Registration Card
1
2
Oil drain hose
1
Read the Operator’s Manual and
watch the video before operating
the machine.
Note: Deter mine the left and right sides of the mac hine from the nor mal operating position.
Step
1
Checking the Fluids and Tire
Pressure
No Parts Required
Procedure
• Before y ou star t the engine and use the
mac hine , c hec k the oil lev el in the engine
crankcase; refer to Chec king the Engine Oil
Lev el.
• Chec k the g rease for the mo w er and mo w er
dec k.
• Chec k the tire pressure; refer to Chec king the
Tire Pressure .
Note: T he cutting blades are set to a 3 inc h
(76mm) height-of-cut at initial purc hase . T he
axle position is D , with 4 spacers belo w both the
spindle and the caster .
Step
2
Reading the Manual and
Viewing the Safety Video
Parts needed for this step:
1
Operator’s Manual
1
Engine Operator’s Manual
1
Parts Catalog
1
Safety Video
1
Registration Card
1
Oil drain hose
Procedure
• R ead the Operator’ s Manual .
• View the safety video .
• Fill out the registration card and mail it in or
register online at www .T oro .com .
• Use the oil drain hose when c hanging the
engine oil.
11