Operator's Manual

5. Adjust the threaded y ok e at the bottom of the
speed control linkag e until the tabs are at the
6 o’cloc k position ( Figure 33 ).
Figure 33
1. Speed control rod
4. Tabs, 6 o’clock position
2. Yoke
5. Jam nut
3. Speed control crank
6. Pull the speed control lev er bac k to neutral.
7. Chec k to mak e sure the safety switc h is
de pressed and there is a 5/16 inc h (8 mm)
space betw een the actuating tab and the switc h.
( Figure 34 ).
8. If needed, adjust switc h location to create the
5/16 inc h (8 mm) space ( Figure 34 ).
Figure 34
1. Actuating tab 3. Safety switch
2. 5/16 inch (8 mm) space
Adjusting the Neutral
Control Linkages
Engine must be r unning so contr ol linka ge
adjustments can be perf or med. Contact
with mo ving par ts or hot surf aces may cause
per sonal injur y .
K eep hands, feet, f ace, clothing and other
body par ts a w ay fr om r otating par ts, muf fler
and other hot surf aces.
Mechanical or h y draulic jacks may f ail to
suppor t machine and cause a serious injur y .
• Use jack stands when suppor ting
machine.
• Do not use h y draulic jacks.
1. Diseng ag e the PTO and set the parking brak e .
33