Operator's Manual

2.Removethelatchpin,slidethecasterfromthe
support,andchangethespacers(Figure20).
3.Installthecasterinthesupportandinsertthelatch
pin(Figure20).
AdjustingtheHandleHeight
Thehandlepositioncanbeadjustedtomatchthe
operator’sheightpreference.
1.Removethehairpincotterpinsandclevispinsfrom
thedriveleversandneutrallocks(Figure21).
Figure21
1.Controlrod5.Lefthandleshown
2.Clevispin
6.Neutrallock
3.Drivelever7.Hairpincotterpin
4.OperatorPresence
Controllever(OPC)
2.Loosentheupperangebolts(3/8x1-1/4inch)
andangenutsecuringhandletorearframe
(Figure22).
3.Removethelowerangebolts(3/8x1inch)
andangenutssecuringhandletorearframe
(Figure22).
4.Pivothandletodesiredoperatingpositionand
installlowerangebolts(3/8x1inch)andange
nutsintomountingholes.Tightenallangebolts.
Figure22
1.Controlrodtting
7.Lowerposition
2.Lowermountingholes8.Uppermountinghole
3.Rearframe
9.Handle
4.Lowerangebolt(3/8x1
inch)
10.Flangenut(3/8inch)
5.Upperangebolt(3/8x
1-1/4inches)
11.
6.Highposition
5.Adjustthecontrolrodlengthbyrotatingthecontrol
rodintherodtting(Fig.8).
6.Installhairpincotterbetweendriveleversand
neutrallocksandintoclevispins(Fig.25).
Note:Makesuretheclevispinsareinsertedinto
theneutrallocks.
7.Performthehydrauliclinkageadjustmentswhenthe
handleheightischanged;referHydraulicLinkage
Adjustments.
24