Service Manual

Groundsmaster 4500 --D/4700--D Page 7 -- 23 Chassis
Removal (Fig. 22)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. Release hood latches and raise hood.
3. Remove hair pins and washers from pivot pins on ra-
diator frame.
4. Remove hood from pivot pins and machine.
5. If necessary, disassemble hood using Figure 22 as
a guide.
6. Check b ulb seals on screen (item 1) and replace
seals if damaged.
Installation (Fig. 22)
1. If components were removed from hood, assemble
hood using Figure 22 as a guide.
2. Slide hood frame onto radiator frame pivot pins.
3. Secure hood to frame with hair pins and washers.
4. Check hood alignment for correct operation of hood
latches and dust s eals.
Chassis