Service Manual

Table Of Contents
Groundsmaster 4500D/4700DPage 5 10Electrical System
Main Menu Screen
The main menu screen can be accessed from the Info-
Center main information or splash screen by pressing
and releasing the menu/back button (left button) on the
display. Once to the main menu screen (Fig. 12), naviga-
tion to the five (5) different menu items can occur. Press-
ing the move to menu item button (center button) allows
a different menu item to be highlighted. Selection of the
highlighted item is completed by pressing the choose
item button (right button).
The main menu items include faults, service, diagnos-
tics, settings and about. These menu items are de-
scribed below.
To return to the main information screen from the main
menu screen, press the back button (left button).
1. Main menu
2. Menu items
3. Move to menu items
4. Choose menu item
5. Back button
Figure 12
1
3
4
5
3
4
Main Menu
Faults
Service
Diagnostics
2
5
Faults Screen
The faults screen (Fig. 13) will list all machine electrical
faults that have occurred since the faults were last
cleared from the InfoCenter. The faults will be identified
by a fault number and when the fault occurred. Faults
that might occur on the machine are listed in Fault
Codes in the Troubleshooting section of this chapter.
After entry of the PIN code, the InfoCenter fault log can
be cleared by selecting the clear system faults menu
item. The cleared faults will be removed from the Info-
Center list but will be retained in the TEC controller
memory.
If a fault occurs during machine use, there may be a
change in machine functionality due to the fault. Should
there be machine operation issues due to a fault, a first
step to remedy the issue would be to disengage the cut-
ting decks, release the traction pedal, turn the ignition
switch OFF and allow all machine functions to stop.
Then, attempt to restart the machine to see if operation
has returned to normal. Some faults will be reset during
the restart and will then allow normal function. If a fault
continues to occur, further system evaluation and pos-
sible component repair or replacement will be neces-
sary.
To return to the main menu screen from the faults
screen, press the back button (left button).
1. Fault menu
2. Fault items
3. Move to menu items
4. Choose menu item
5. Back button
Figure 13
1
3
5
3
4
Faults
#6
Clear System Faults
57.3 Ago
2
5