Operator's Manual

Premaintenance
Procedures
Removing the Hood
T o g ain additional access to engine compar tment,
the hood ma y be remo v ed from traction unit.
1. R elease hood latc hes ( Figure 20 ) and raise
hood.
Figure 20
1. Hood latch
2. Unhook lanyard from hood pin, remo v e pin
and slide hood tubes rearw ard off guides
( Figure 21 ).
Figure 21
1. Hood pin
Lubrication
Greasing the Bearings and
Bushings
T he mac hine has g rease fittings that m ust be
lubricated regularly with No . 2 General Pur pose
Lithium Base Grease . If the mac hine is operated
under nor mal conditions , lubricate all bearings
and bushings after ev er y 50 hours of operation or
immediately after ev er y w ashing .
T he g rease fitting locations and quantities are as
follo ws:
• Brak e shaft pi v ot bearings (5) ( Figure 22 )
Figure 22
• R ear axle pi v ot bushings (2) ( Figure 23 )
Figure 23
• Steering cylinder ball joints (2) ( Figure 24 )
32