Operator's Manual

Figure 37

1. Fuel Injectors (3)

2. Move the throttle to the FAST position.

3. Turn the key in the key switch to the START

position and watch fuel flow around the

connector. Turn the key to the OFF position

when solid flow is observed.

4. Tighten the pipe connector securely.

5. Repeat these steps on the remaining nozzles.

Engine Cooling System

1. Removing Debris—Remove debris from the

oil cooler and radiator daily, clean more

frequently in dirty conditions.

A. Turn the engine off and raise the hood.

Clean the engine area thoroughly of all

debris.

B. Remove the access panel.

Figure 38

1. Access panel

2. Oil cooler

3. Radiator

C. Remove access panel. Unlatch the oil

cooler and pivot rearward. Clean both sides

of the oil cooler and radiator area

thoroughly with water or compressed air.

Pivot the oil cooler back into position.

Figure 39

D. Install access panel and close the hood.

Servicing Engine Belts

Check the condition and tension of all belts after

the first day of operation and every 100 operating

hours thereafter.

Alternator/Fan Belt (Fig. 40)

1. Open the hood.

2. Check tension by depressing the belt midway

between the alternator and crankshaft pulleys

with 30 Nm of force. The belt should deflect

1.12 cm. If deflection is incorrect, go to step 3.

If correct, continue operation.

Maintenance

– 27 –