Installation Instructions

2
InstallingtheLift-Arm
Assembly
Model30810
Partsneededforthisprocedure:
1
Cylinder-supportassembly
2
Bolt(3/8x2-3/4inches)
3
Bolt(3/8x1-1/4inches)
1
Bolt(3/8x1inch)
3
Nut(3/8inch)
1
Lift-armassembly
2
Bolt(7/8x4-1/2inches)
2
Jamnut(7/8inch)
8
Spindlewasher
1
Bolt(1/2x1-1/2inches)
1
Locknut(1/2inch)
1
Cylinder-mountpivotpin
1
Greasetting
Procedure
Note:Togainadditionalaccessduringtheassemblyofthe
kit,raisetherearofthetractionunit,supportitwithjack
stands,andremovetheright,reartire.
1.Removetheexisting3boltsand3nutsfromtheskid
assembly(Figure1).
Note:Retainthenuts.
Figure1
1.Bolt2.Nut
2.Securethecylinder-supportassemblytothe
rear-bumperbracketandskidassemblywith2bolts
(3/8x2-3/4inch),3bolts(3/8x1-1/4inch),2
nuts(3/8inch),andthe3existingnutsthatyoujust
removed.
Note:Positionthecylinder-supportassemblyas
showninFigure2.
Figure2
1.Nut(3/8inch)
4.Rear-bumperbracket
2.Cylinder-support
assembly
5.Bolt(3/8x2-3/4inch)
3.Bolt(3/8x1-1/4inch)
6.Existingnut
3