Service Manual

Groundsmaster 3500Page 7 - 8Wheels, Brakes, and Chassis
Service and R epairs
Standard Seat
1. Seat (incl. 4 thru 7, 14, & 15)
2. Seat belt
3. Lock washer
4. Cap screw
5. Armrest
6. Cap screw
7. Flange hex nut
8. Screw
9. Hexflangehdscrew
10. Spacer
11. Armrest bracket
12. Washer
13. Hex flange hd screw
14. Seat support strap
15. Seat adjuster with latch
16. Seat adjuster
17. Seat switch
18. Hex flange head screw
19. Hex flange head screw
20. Flange hex nut
21. Cap screw
22. Lock washer
23. Spacer
Figure 10
5
2
3
4
2
1
6
4
3
7
8
9
10
11
12
13
14
14
15
16
17
18
19
20
20
22
21
22
23
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Remove four hex flange head screws securing the
seat support straps to the frame. Note location of
spacers under front of seat support straps.
3. Disconnect electrical connector from the seat switch.
Separate seat from the frame.
4. Remove seat parts as necessary to make repairs
(Fig. 10).
Installation
1. Install any new seat parts (Fig 10).
2. Position seat, spacers and support straps to the fuel
tank and frame.
3. Connec t electrical connector to the seat switch.
4. Secure seat support straps t o the frame with four hex
flange head screws.