Service Manual

31. Put two alignment pins into the metering ring

(Fig. 94).

Figure 94

32. Stack the isolation manifold (4 plates bonded to-

ther) onto the metering ring, aligning the grooves on

the side of the manifold with the grooves on the side of

the upper cover plate (Fig. 95). Align the alignment pin

holes with the alignment pins in the metering ring. The

isolation manifold surface without the recessed slots

must be toward the metering ring.

Figure 95

33. Install two alignment pins into the isolation manifold

(Fig. 96).

Figure 96

Repairs P

age 8 - 46 Groundsmaster 300 Series