Operator's Manual
$ 1 (1 -#$* - 1 ,# /# $ 1
./(,& 2,#$/ 1$,0(-, 20$ " 21(-,
(,01 **(,& 0./(,& ,# .(,
(Model 30741 only) Remove flange screw and
locknut securing sealing plate, over fuel tank, to frame
(Fig. 6). Remove sealing plate.
(&2/$
$ 1 4(1"'
$ 1 2..-/1 / ")$1
$ *(,& * 1$
./(,&
(,
Insert pin part way into hole in top of seat support
bracket on machine (Fig. 6).
Slide spring up onto pin while pushing down on
pin.
Pry top of spring down and insert roll pin through
pin.
Check operation of pin.
(Model 30741) Reinstall sealing plate to frame,
above fuel tank with flange screw and locknut
previously removed.
Loosely secure (2) R-clamps to right side of seat
bottom with (2) capscrews and flatwashers supplied in
kit (Fig. 7). Install manual tube into R-clamps and
tighten capscrews (Fig. 7).
(&2/$
"* +.0
$ 1 02..-/1
,2 * 12!$
.
Mount seat pivot bracket to frame with (2) flange
screws supplied in kit (Fig. 8)
(&2/$
$ 1 (3-1 / ")$1
Mount seat and seat support to seat pivot bracket
with pivot shaft and roll pin (Fig. 9).
(&2/$
(3-1 0' %1 -** .(,
Hold seat up with seat support rod (Fig. 10).
(&2/$
$ 1 2..-/1 -#
$ 1 (1 -#$* - $*25$ $ 1 4(1' -#$*
$ 1 # .1$/ (1
./(,& 2,#$/ 1$,0(-, 20$ " 21(-,
(,01 **(,& 0./(,& ,# .(,
(Model 30741 only) Remove flange screw and
locknut securing sealing plate, over fuel tank, to frame.
Remove sealing plate.
Insert pin part way into hole in top of seat support
bracket on machine (Fig. 7).