Operator's Manual
$ 2 #)312(-& $4$0 (Fig. 30)ĊTo adjust standard
seat, push lever backward and slide seat to the desired
position. Release lever to lock seat in place. The
suspension seat may be adjusted forward or rearward
by pulling out the lever at the left side of the seat, sliding
the seat to the desired position, and releasing the lever.
The weight adjustment knob may be adjusted for any
operator's comfort.
(&30$
$ 2 #)312(-& +$4$0
The fuel system must be bled if any of
the following situations have occurred:
A. Initial start up of a new machine.
B. Engine has ceased running due to lack of fuel.
C. Maintenance has been performed upon fuel
system components; i.e. filter replaced,
separator serviced, and so on.
$%$0 2. +$$#(-& 3$+ 712$,
Ensure parking brake is set, PTO lever is in OFF
position, and lift lever is in TRANSPORT or FLOAT
position. Remove foot from traction pedal and insure it
is in neutral.
Move throttle control to full FAST position.
Push glow plug switch to ON position and hold
until indicator glows red. Continue to hold switch in
position for suggested interval and turn key in key
switch to START position. Release glow plug switch
after engine starts and allow key to return to RUN
position. Move throttle control to SLOW position.
.2$ . -.2 $6"$$# ,(-32$ .% ".-2(-3.31 31$ .0
&+.5 /+3& , 7 % (+ /0$, 230$+7
.2$ Refer to chart indicating approximate preheat
time suggested in various temperature ranges.
$,/$0 230$
Above 41F (5C)
0$'$ 2 2(,$ 1$"
23Fto41F
Below 23F (Ć5C)
10
20
30
.2$ . -.2 03- 12 02$0 ,.2.0 ,.0$ 2' -
1$".-#1 2 2(,$ .0 /0$, 230$ 12 02$0 % (+30$ , 7
0$13+2 % $-&(-$ % (+1 2. 12 02 %2$0 1$".-#1 230-
*$7 2. /.1(2(.- 0$"'$"* ".-20.+1 -#
/0."$#30$1 5 (2 ##(2(.- + 1$".-#1 -# 0$/$ 2
12 02$0 /0."$#30$
Turn key in key switch to START position. Release
key immediately when engine starts and allow it to
return to RUN position. Move throttle control to SLOW
position.
When engine is started for the first time, or after
overhaul of the engine, transmission or axle, operate
the machine in forward and reverse for one or two
minutes. Also operate the lift lever and PTO lever to
assure proper operation of all parts. Turn steering
wheel to the left and right to check steering response.
Then shut engine off and check for oil leaks, loose
parts, and any other noticeable difficulties.
'32 $-&(-$ .%% -# 5 (2 %.0 ++ ,.4(-& / 021 2.
12./ !$%.0$ "'$"*(-& %.0 .(+ +$ *1 +..1$ / 021
.0 .2'$0 #(%%("3+2($1
To stop engine, move throttle control backward to
SLOW position, move PTO lever to OFF position, and
rotate ignition key to OFF. Remove key from switch to
prevent accidental starting.