Operator's Manual
The traction unit must be lubricated regularly. If
machine is operated under normal conditions,
lubricate all bearings and bushings after every 50
hours of operation.
The traction unit bearings and bushings that must
be lubricated are: PTO shaft and yokes (Fig. 24); lift
arm pivots (Fig. 25); right and left push arm ball joints
(Fig. 24); push arm pivot bushings (Fig. 26); PTO pivot
housing blocks (Fig. 27); brake pivot bushings
(Fig. 28); rear wheel spindle bushings,steering plate
bushings, axle pin bushing, steering cylinder (2)
(Fig. 29) and engine output shaft bearing (Fig. 30).
Also apply grease to both brake cables at the drive
wheel and brake pedal ends.
"!
DUPE OLD FIGURE 24
"!
DUPE OLD FIGURE 25
"!
DUPE OLD FIGURE 26
"!
DUPE OLD FIGURE 27
"!
NEW FIGURE