Operator's Manual
,0# Use this chart as a checklist to ensure all parts necessary for assembly have been shipped. If any of these
parts are missing, total set-up cannot be completed.
Registration Card 1 Affixed to machine.
Hydraulic Oil Filter 1 Change after 10 hours
Steering Wheel 1
Foam Seal 1
Nut 1 Install Steering Wheel
Screw 1
Cap 1
Manual Tube (shipped in tool box) 1 Install on right underside of seat
R-Clamp 2
Ball Joint R.H. (Shipped in tool box) 1 Install Ball Joint (implement installation)
and Connect Lift Cylinder.
Operator's Manual (Traction Unit) 2 Read before operating machine
Parts Catalog 1
Engine Dealer Listing 1
-#!'$'!0',+/ +" "#/'%+ /1 (#!0 0, !&+%# 2'0&,10 +,0'!#
Remove jam nut from steering shaft. Slide foam
seal and steering wheel onto steering shaft.
Secure steering wheel to shaft with jam nut and
tighten it to 10-15 ft-lb.
Install cap to steering wheel with screw.
'%1.#
0##.'+% &##)
* 10
-
!.#2
,* #)