Service Manual

Bidirectional Clutch Service
Hylomar Jointing
Compound
DRIVE
1
15
17
7
3
4
5
6
8
2
9
10
11
14
12
13
16
18
(19 N–m)
REAR
SHAFT
AXLE
14 ft–lb
Figure 35
1. End plate 7. Phillips head screw w/o–ring 13. Oil seal
2. Socket head screw (6 used) 8. Hub
14. Bearing Housing
3. Oil seal 9. Needle
bearing 15. Bearing
4. Snap ring 10. Thrust
washer 16. Snap ring
5. Bearing 1
1. Wave spring 17. Retaining ring
6. Housing 12.
Roller cage assembly 18. Oil seal
Disassembly (Fig. 35) 3. When installing oil seals, make sure that seal lips are
facing in.
1. Thoroughly clean exterior of clutch before disassem-
bly. 4.
Apply Hylomar Jointing Compound (or equivalent) to
end plate (item 1) mating surface before installing end
2. Disassemble clutch using Figure 35 as a guide.
plate.
Assembly (Fig. 35)
5.
Secure end plate with six (6) socket head cap
screws. Torque screws 14 ft–lb (19 N–m).
1. Lightly lubricate clutch components with clean Mobil
Fluid 424 before assembly
.
2. Assemble clutch using Figure 35 as a guide.
4WD Rear Axle (Rev. G) Page 10.1 – 20 Groundsmaster 328–D
(Dae Dong Axle)