Operator's Manual
After every 400 hours of operation, the oil in the
bidirectional clutch must be changed.
Position the machine on a level surface.
Clean area around check plug on bidirectional
clutch.
Rotate clutch so check plug is positioned
downward (Fig. 69).
$"+)!
$ $)!*$('& &+*#
#!% &+"
Remove check plug allowing all lubricant to flow
into drain pan.
Rotate clutch so check plug is positioned at 4
O'clock.
Add Mobil Fluid 424 until lubricant level is up to
hole in clutch. Clutch should be approximately 1/3 full.
Install check plug.
(*! Do not use engine oil (i.e. 10W30) in bidirectional
clutch. Anti-wear and extreme pressure additives will
cause undesirable clutch performance.