Operator's Manual

Figure 15

Figure 16

GREASING BEARINGS, BUSHINGS,

GEAR BOX AND BRAKE CABLES

The traction unit must be lubricated regularly. If the machine is

operated under normal conditions, lubricate all bearings and

bushings after every 50 hours of operation.

The traction unit bearings and bushings that must be lubricated

are: the PTO shaft and yokes (Fig. 15); lift arm pivots(Fig.16);

right and left push arm ball joints (Fig. 15); push arm pivot

bushings (Fig. 17); PTO pivot housing blocks (Fig. 18); brake

pivot bushings (Fig. 19); rear wheel spindle bushings (Fig. 20,

21); steering plate bushings (Fig. 21); axle pin pushing (Fig.

21); and engine output shaft bearing (Fig. 22). Also apply

grease to both brake cables at the drive wheel and brake pedal

ends.

Figure 17

Figure 18

Figure 19

Figure 20