Operator's Manual
Slide spring up onto pin while pushing down on
pin.
Pry top of spring down and insert roll pin through
pin.
Check operation of pin.
(Model 30739) Reinstall sealing plate to frame,
above fuel tank with flange screw, truss head screw, (2)
locknuts and spacer previously removed.
(Model 30739) Reinstall seat switch to support
bracket. Adjust switch height so there is 1/16" (1.6 mm)
clearance between top of switch and seat plate when
lynch pin is installed. Tighten jam nuts securely.
Reinstall boot to switch.
Loosely secure (2) R-clamps to right side of seat
bottom with (2) capscrews and flatwashers supplied in
kit (Fig. 4). Install manual tube into R-clamps and
tighten capscrews (Fig. 4).
Check interlock switch operation with lynch pin
installed.
(&2/$
"* +.0
$ 1 02..-/1
,2 * 12!$
Mount seat pivot bracket to frame with (2) flange
screws supplied in kit (Fig. 5).
(&2/$
$ 1 (3-1 / ")$1
Mount seat and seat support to seat pivot bracket
with pivot shaft and roll pin (Fig. 6).
(&2/$
(3-1 0' %1 -** .(,
Hold seat up with seat support rod (Fig. 7).
(&2/$
$ 1 2..-/1 -#
$ 1 (1 -#$* - $*25$ $ 1 4(1' -#$*
$ 1 # .1$/ (1
./(,& 2,#$/ 1$,0(-, 20$ " 21(-,
(,01 **(,& 0./(,& ,# .(,
(Model 30739 only) Remove boot from button end
of seat switch (Fig. 3). Pull connectors off switch
terminals.
(Model 30739 only) Remove top jam nut securing
switch to mounting bracket and remove switch.
(Model 30739 only) Remove flange screw, truss
head screw, (2) locknuts and spacer securing sealing
plate, over fuel tank, to frame (Fig. 3). Remove sealing
plate.
Insert pin part way into hole in top of seat support
bracket on machine (Fig. 3).
Slide spring up onto pin while pushing down on
pin.
Pry top of spring down and insert roll pin through
pin.
Check operation of pin.
(Model 30739) Reinstall sealing plate to frame,
above fuel tank with flange screw, truss head screw, (2)
locknuts and spacer previously removed.