Service Manual

Body Assembly-Reassembly
Note: Transmissions with sealed bearings incorporate
an oil seal under the output bearing.
“Retaining Sealed
Ring
Flow
Through
Bearing
Output Shaft
Fig.
58
107 When applicable, install oil seal in body with the
rubber lip toward the counter bore in the body. Press or
tap the seal into the bottom position in the counter
bore.
Important: Do not over press or drive the oil seal.
This may damage the rubber sealing portion
of the
oil seal.
108 Install output bearing. Position bearing on the body
and press on the outer bearing race to the bottom
position in the body.
109 Install the bearing retaining ring.
110 Install output shaft. This is a press fit. Be sure to
support the inner race of the ball bearing while pressing
the shaft into the bearing.
Body/Cover-Reassembly
111 Install body. Align the output shaft with the bearing
1ocated: in pintle and shaft cross pin with the
slot in the
motor rotor assembly. Install two
5/16” x 1 1/4” socket head
cap screws Torque to
15 foot pounds.
Important: Be sure the output shaft rotates freely
by hand. If it does not, recheck body installation.
5/16” x 1 1/4” (2)
Fig. 59
Start-up Procedure
112 Fill transmission with fluid. See page 24 for fluid
recommendations. On transmission
that incorporates
flow through output bearing, fill through the axle
to the
manufacturer’s specified fluid level.
On transmissions that incorporate sealed output shaft
bearing$, fill through the reservoir to the manufacturer’s
specified fluid level. Start the engine and run the
transmission in both directions at low engine speed for
a short time
to purge trapped air from the system.
Stop, shut off engine and recheck fluid level. 21
The transmission is now ready for use.