Service Manual
Table Of Contents
69
Turn cover over. Use dimension obtained in Step
68
to locate dowel pin in cover face. Drill
11/32”
diameter
hole at center point of dowel pin. Drill hole exactly in
line with center
of
shaft.
Same as
Dimension measured
Control
Shaft
in Fig.
29
Fig.
30
70
Press damaged pin from control shaft. Remove
control shaft and washer.
Pipe Plug
Fig.
31
71
Tap hole drilled in Step
69
with
1/8”
pipe tap. Install
1/8”
diameter flush type pipe plug.
Cover Assembly-Reassembly
Dowel
Pin
Washer
73
Press new dowel pin through the shaft. Leave
1
1/4”
of dowel extending from the shaft.
74
Lubricate I.D.
of
new oil seal with clean lubricant.
Then press or tap seal in bore until completely seated.
Cover
Fig.
34
important: Be careful not to damage the inner
portion of the oil seal. Excessive pressing or
driving
of
the oil
seal
will
damage the rubber
portion of the oil
seal.
75
Install input shaft in cover.
input Shaft
15
Fig.
35
76
Turn cover over. Support input shaft from
underneath. Use a piece of steel bar stock or hard
shaft cross pin against the cover.
Fig.
32
wood-2 in diameter by at least
2 1/2”
long to keep the
72
Install new control shaft and washer in cover.
Fig.
33