Service Manual

HYDROSTATIC DRIVE SYSTEM
6-30 Fixed Deck Mid-Size Service Manual
6
Fig 816 PICT-6875
14. Install the cotter pin into the wheel motor shaft (Fig.
816).
Fig 815 PICT-6871a
13. Tighten and torque the slotted hub nut to 100 ft-lbs.
(136 Nm) (Fig. 815).
Note: Torque to 100 ft-lbs. (136 Nm), then tighten to
the next slot so the cotter pin can be installed.
Fig 814 PICT-6873a
10. Lower the machine so the rear tires are resting on
the ground.
11. Apply the parking brake.
12. Tighten and torque the 4 lug nuts to 90–95 ft-lbs.
(122-129 Nm) (Fig. 814).
Fig 813 PICT-6869a
9. Snug fi t the 4 lug nuts on the wheel hub studs (Fig.
813).