Service Manual

CHASSIS

5-49Fixed Deck Mid-Size Service Manual

Fig 559 PICT-6750

Fig 561 PICT-6754

3. Loosely install 2 nuts onto the 2 bolts securing the

side ﬂ ange bearing to the hydro control shield (Fig.

559).

5. Install 4 bolts and spacers through the hydro control

shield and into the chassis; secure with 4 nuts (Fig.

561).

Note: The two bottom spacers are approximately

3/8” (.95cm) shorter than the upper spacers.

Fig 560 PICT-6752

Fig 558 PICT-6748

4. Position the hydro control shield so the bearing is

installed on the control shaft (Fig. 560).

2. Insert the 2 bolt assemblies into the hydro control

shield and position the side ﬂ ange bearing (Fig.

558).