Operator's Manual

Figure11
1.Blade
4.Spacer
2.Bladebolt5.Thinwasher
3.Curvedwasher
6.Nut
4.Slidetheboltdownthroughthespindle,andchange
thespacersasneeded(Figure11).
5.Installtheboltandcurvedwasher,addextraspacer(s),
andsecurethemwithathinwasherandanut(Figure
11).
6.Torquethebladeboltto101to108N-m(75to
80ft-lb).
AdjustingtheAxleHeight
Adjusttheaxlepositiontotheselectedheight-of-cutsetting.
RefertotheHeight-of-CutChart.
1.Disengagetheblade-control(PTO)leverandsetthe
parkingbrakes.
2.Stoptheengineandwaitforallmovingpartstostop
beforeleavingtheoperatingposition.
3.Loosen,butdonotremove,the2axlepivotboltsand
the2axleadjustmentbolts(
Figure12).
Figure12
1.Axlepivotbolt2.Axleadjustmentbolt
4.Placeajackundertherearcenteroftheengineframe.
Raisethebackendoftheengineframeupenoughto
removethefront2axleadjustmentbolts(Figure12).
Note:Usejackstandstosupportthemachine.
5.Raiseorlowertheengineframewiththejacksothat
youcaninstallthefront2axleadjustmentboltsinthe
desiredholelocation(
Figure12).
Note:Useataperedpunchtohelpaligntheholes.
6.Tightenall4boltsandlowerthemower.
7.Adjustthecontrolrodsandthebrakelinkagesas
required.RefertoServicingtheBrakesandAdjusting
theControlRods.
Important:Youmustadjustthecontrolrods
andthebrakelinkagewhenyouchangetheaxle
positionsforpropertractionandbrakefunction.
AdjustingtheCasterPosition
1.UsingtheHeight-of-CutChart,adjustthecaster
spacerstomatchwiththeaxleholeselected(
Figure13).
Figure13
1.Latchpin
3.Spacer,13mm(1/2inch)
2.Spacer,5mm(3/16inch)
2.Removethelatchpin,slidethecasterfromthesupport,
andchangethespacers(Figure13).
18